Mustang® Seamless Aluminium Gutter system is the only BBA certified seamless aluminium system available the UK. It is produced on site by a specialist roll forming gutter machine. The main benefit of choosing Mustang® is that lengths of up to 30 metres can be produced and installed thus eliminating the presence of any joints and therefore any potential for leaks.
Composition and ManufactureGutter formed on site from Hydrocoat Textured 800 Aluminium 0.9mm thick 3105 grade H45 CoilComponents made from colour matched UV stable PolycarbonateMatt Finish (40% reflectivity)BBA Certificate No 91/2625Life expectancy of over 30 yearsInstallation
The gutter is crimped centrally near the edge of the rear, front and base to create raised fixing nibs.
The end cap is pressed home activating the internal slotted securing clips to fully engage over the fixing nib, ensuring a non-removable fitting. The completed fitting is sealed inside the gutter with at least three beads of sealant, minimum diameter 7mm.
Roll-forming to the exact gutter length is then completed. Aluminium fixing brackets are clipped into position at centres not exceeding 450mm as roll-forming is continued.
The formed gutter is cut to length and a stopend fitted to the remaining open end.
Corners are formed by mitring the ends of the gutter lengths and connecting with a two-piece polycarbonate locking corner fitting, which is then sealed with a specific sealant and secured with stainless steel screws.
Connector expansion joints are installed in the same manner.
The gutter is positioned and fixed with 4mm diameter, 30mm long stainless steel, self tapping screws.
The fixings are located in pre-drilled holes in the fixing brackets and driven through the back of the gutter into the fascia.
Colour Options
